Furnace Repair in Easton, MD
Furnaces here run from October through April. If yours quits, tell us what it's doing and a licensed contractor who covers Talbot County will get in touch.
Tell us about the job
It takes about a minute.
Talbot County winters keep your furnace working from October to April
Seven months of the year, your furnace is what stands between your house and a 29°F night. That means a lot of cycles on and off, and every start puts a little more wear on the igniter and the parts that get the burner lit. When one of those parts finally gives out, you notice it fast, because the house cools down quick on a night that cold.
Most homes in Talbot County heat with electricity, so a power outage takes the furnace down with it, not just the lights. Winter storms and wind are not rare here. Over the past ten years the county has seen 9 winter storms and 93 damaging wind events, and across Maryland, 11% of households lost power for at least a day in 2024. When the power drops on a cold night, a furnace that was already struggling is the one that will not come back on.
- 7 months
- October through April, your furnace is on duty
- 29°F
- the average winter night it heats against
- 9 winter storms
- in ten years, the nights a failure hurts most
NOAA nClimDiv, 1991–2020 normals
Maryland requires HVAC contractors to hold a state license.
The state board tests HVAC contractors before they get a license, and it keeps a record of who holds one. That license belongs to the contractor, not to the job, so it doesn't get reissued or checked off each time someone comes out to your house. It's the state's way of saying this person has shown they know the trade.
For a furnace repair, this is the license that stands behind the work. Gas furnaces have a gas connection that has to be sealed and burning correctly, and a licensed contractor is the one Maryland holds responsible for getting that right in your home in Talbot County.
Sources: Maryland General Assembly · Maryland Department of Labor
- Why won't my furnace turn on?
- Most often the thermostat isn't calling for heat the way it should, or power isn't reaching the furnace. Check that the thermostat is set below room temperature and has working batteries if it uses them. The furnace switch, which looks like a light switch near the unit, needs to be on, and the breaker for it needs to be up. If those are fine, the igniter or the flame sensor may have failed, and that's a job for a licensed contractor to diagnose.
- Why is my furnace blowing cold air?
- If air is moving but it isn't warm, the furnace may be running the blower without the burners lighting. A dirty flame sensor can cause the burners to shut off right after they start, which leaves the blower pushing unheated air through the vents. A clogged filter can also cause the furnace to overheat and cut the burners while the fan keeps running. Either way, this points to a repair rather than something to wait out.
- Why won't my furnace pilot light stay lit?
- This usually means the thermocouple has worn out. That's the small part that sits in the pilot flame and tells the gas valve the flame is lit. When it fails, the valve shuts the gas off as a safety measure even though the pilot looks fine when you light it. A contractor licensed by the state can replace the thermocouple, which fixes this in most cases.